App does not detect Wi-Fi product during set up

The Bose app uses Bluetooth Low Energy (BLE) to detect nearby Bose speakers. Be sure Bluetooth is enabled on the device running the app.

If Bluetooth is off, the following message will appear when device discovery is initiated:

Keep the device you want to connect close to your Bose product to be sure it is within range of the Wi-Fi network broadcasted by your product

If your device does will not connect to the setup network of your Bose product, go to your device Settings, select Cellular and disable Wi-Fi Assist. Then, tap the Bose network name to connect to it. (Note: Wi-Fi Assist is available on iOS 9 and later.)

On the device running the Bose app, go to the Wi-Fi settings and turn Wi-Fi off and back on again

Much like rebooting a smartphone, your product might need to be reset on occasion to correct minor issues. For more info, see Resetting your product.

Electronics might need to be rebooted from time to time to correct minor issues. This is typically done by powering off the device completely and then powering it back on again.

Routers may need to be reset from time to time—much like rebooting a computer. Disconnect power from the router for 30 seconds, then wait for it to start up and connect. (Note: Any device connected to the Internet will be interrupted during the reset.)

Location permissions are used by the Bose app to detect and control your product. If location settings are disabled for the app, it will not work properly.

• For iOS devices:
  1. Go to Settings > Privacy > Local Network and be sure it is not disabled for the Bose app
  2. Go to Settings > Privacy > Location Services and be sure it is not disabled for the Bose app
• For Android devices, touch and hold the app icon, then tap App Info from the pop-up that appears. On the App Info screen, tap Permissions and be sure Your location is enabled.

If your product cannot connect to your network using the normal setup method in the Bose app, try an alternate method. For more info, see Connecting to a Wi-Fi network.

Many routers broadcast multiple networks, like a 2.4 GHz network, a 5 GHz network, and a guest network. If you see multiple networks with the same name when connecting a device to Wi-Fi, some devices might not be connected to the expected network.

In your router settings, try temporarily disabling the 5 GHz network and guest network. If the issue is resolved by using only the 2.4 GHz network, rename he 5 GHz network and guest network to something different than the 2.4 GHz network (i.e. MyNetwork2G, MyNetwork5G. and MyNetworkGuest). This will help you and your devices identify the correct network. (Tip: If you rename a network, any devices that were connected to the previous network name will need to be reconnected to the new network name in the device settings menu.)

Log in to your router and look for an option labeled Access Point / AP mode, Wireless Isolation mode, or Wireless AP mode. This might be located in the wireless settings menu. If enabled, try disabling the option. If there is no improvement, you can always switch back to the previous setting.

Network extenders are used to extend the range of a network to cover a large area. Check if the issue is related to an extender by temporarily unplugging it. Since unplugging it might reduce the range of your network, move your system closer to the main router to test if the issue improves:

• If it does not improve, the issue is not related to the extender.
• If it does improve, try reconnecting the extender. Sometimes it can help to connect extenders after connecting to the main network.
• If it does improve but returns after reconnecting the extender, the issue could be related to the extender, its settings or placement.

For more info, see Resetting your product.